Tools in the DCS

Reliability and safety in the manufacturing process of the DCS. In addition to industrial control systems of the specific installation tools that are reliable, then. The design must also consider safety and limit the loss of production from various accidents or errors within the limited scope of most.


Control system to limit damage caused by defects or failure of K Engineering to hand within the limit.
Control systems to provide backup for control Vice hand control staff are able to control the manufacturing process to replace the main control section that has been able to do damage to normal soon.
Control system must provide protection system that pungent, Chen M for control staff can be ordered to stop and cancel all or part of the production process immediately all safety procedures.
Control system must be self-monitoring system for checking the accuracy of the operation was.

DCS increased the Church’s message holds and safety performance of industrial process control as follows.

Distribution of access equipment and process control of the DCS group were sub-divided the responsibility to monitor and supervise the manufacturing process of industrial indoor keeping the reliability of control systems are increasingly included.

Storage and backup program for performance instead of process control unit of the DCS by the fact type of sleep per Tile Wall internal memory storage of the program will function.

Installation provision for control instead of performance and process control unit connected to the process and the damage can not function normally. Tool control is acting.

Check the DCS system to check the performance of the tools within the system control and monitoring of contact with other tools connected to the DCS to perform with the accuracy at all times. Self-inspection system, and DCS has also instructed the alternate control tools that can come if DCS duty to replace the main control the damage as soon as detected. Disorders of the tool. The process can be carried out successfully with from time to time.

Posted in: DCS